1. Burning yellow: Take the fermented liquid material into the rake, cover the cover, connect the cylinder, the lower edge of the cover and the joint of the pot, the joint of the pneumatic machinery and the cover, the joint of the cylinder and the condenser, and the tank should be filled with water to seal. When the cooking stove is ignited and boiled at the beginning, special attention should be paid to pulling the rake regularly, and the rake should be pushed and pulled at different angles, so as to bring all parts of the bottom of the pot to the rake as far as possible. The purpose of raking is to make the liquid material in the pot scrape up with the rake without settling the bottom of the pot. When the liquid material is boiled and boiled, the phenomenon of boiling is that the rake hole is pulled out to emit alcohol, the hot cylinder is not dared to touch by hand, and the outlet pipe of the lower air chamber of the condenser drinks wine at the beginning, so the rake hole is tightened to avoid running out of gas. After boiling, the liquid material boils up and down, so there is no need to rake it until the boiling is over.

　　2、测酒。但凡烧煮过程，不管是从酒锅，气缸还是冷凝器，从哪个部位冒气都是跑酒。所以说整个酿酒设备各处都不能有破绽和裂纹。密封槽里的一直坚持不短少。则开端也就是“头酒”，也就是大家通常所说“流上洒”，这里酒的度数高，越往后酒的度数逐步降低。用温度表（比重计）互相配合，在与视野程度的位置上，读出此时的温度与酒度，然后依据所测出的读数，在酒精换算表虽温度与洒精度两线穿插点处，打出相同的换算数，即可得出你丈量时该酒样的实践度数，依据你当地消费者喜欢饮用的酒度，来调整该锅酒的出酒量，高度酒畅销就特地消费高度酒，低度酒畅销就特地消费低度酒，一句话，以销定产。要高度酒就早掐尾，要低度酒就晚掐尾，随本人的意愿来灵敏控制。

　　2. Alcohol measurement. But whenever the cooking process, whether from the pot, cylinder or condenser, from which part of the gas is running wine. So the whole brewing equipment can not be cracked everywhere. The sealing groove has been adhered to a lot. Then the beginning is the "head wine", which is commonly referred to as "sprinkle on the stream", where the degree of wine is the highest, and the later the degree of wine gradually decreases. Use thermometer (hydrometer) to coordinate with each other, read out the temperature and alcohol content at this time in the position of visual field degree, and then, according to the measured readings, make the same conversion number at the intersection point of temperature and sprinkler precision of alcohol conversion table, so as to get the practical degree of the wine sample when you measure, according to your local consumption. Consumers like to drink alcohol, to adjust the pot wine output, high-alcohol best-selling on the special consumption of high-alcohol, low-alcohol liquor best-selling on the special consumption of low-alcohol liquor, in a word, to sell and produce. Early tail-pinching is necessary for high alcohol consumption, and late tail-pinching is necessary for low alcohol consumption, which can be controlled sensitively according to one's wishes.

　　3、接尾酒。等到出酒管流出酒度数低于你所需求的酒度时，即可把接酒桶担开，另用桶接尾酒（通常说的稍子），待尾酒度低于10度，该锅酒全部烧煮终了，你所尾的尾酒，把它参加烧煮第二锅酒的液料中一同煮用它同样可出高度酒，一锅接着一循环运用，尾酒一点也不糜费。

　　3. Cocktail. When the liquor outlet pipe is less than the liquor you need, you can open the receiving barrel and use another barrel to connect the tail (usually a little), until the degree of the tail is less than 10 degrees, the whole pot of liquor is boiled, the tail of your tail is boiled, it can be boiled together in the liquid material of the second pot of liquor and use it to produce the same high-level liquor, a pot of liquor. Then it is recycled, and the tail is not wasted at all.

　　以上是全自动凉茬机制造商为大家整理的相关内容，想要了解更多内容，欢迎访问网站：http://www.qfrtrq.com

　　The above is the relevant content of automatic stubble cooler manufacturers for you. For more information, please visit the website: http://www.qfrtrq.com.